Introduction Running a CSI-2 image sensor on an NVIDIA Jetson often sounds more complex than it really is. In practice, the setup is straightforward once the base system is prepared correctly. This guide shows how to bring up the Kurokesu IMX462 camera on the Jetson Orin NX using NVIDIA’s official tools and Kurokesu drivers. Full […]
Read MoreHow to Use IMX462 CSI-2 Cameras with Raspberry Pi
Setting up the IMX462 CSI-2 camera on Raspberry Pi is simple and well documented on our wiki pages. The exact steps vary slightly depending on the Raspberry Pi model, but all follow a similar pattern. Raspberry Pi 4 uses a 15-pin CSI connector, so a 15-to-22 pin FFC cable is needed to connect the camera. […]
Read MoreIMX462 in C3 family – details
We’re expanding the Kurokesu camera family with new models built around the Sony IMX462 image sensor – a standout performer in low-light and near-infrared environments. Designed for starlight-level sensitivity, this sensor offers exceptional performance in dim scenes. Sensor specifications The Sony IMX462 is a 1/2.8″ CMOS sensor optimized for low-light imaging, featuring high sensitivity, low […]
Read MoreC3 camera series gets low-light upgrade
We’re excited to launch our new C3 family cameras featuring the Sony IMX462 image sensor. This upgrade delivers twice the low-light sensitivity compared to our previous C2 models, along with significantly improved performance in near-infrared (NIR) lighting conditions. The update applies to M12 board cameras, CS-mount boxed cameras, and motorized zoom variants, bringing enhanced visibility […]
Read More