Setting up the IMX462 CSI-2 camera on Raspberry Pi is simple and well documented on our wiki pages. The exact steps vary slightly depending on the Raspberry Pi model, but all follow a similar pattern. Raspberry Pi 4 uses a 15-pin CSI connector, so a 15-to-22 pin FFC cable is needed to connect the camera. […]
Read MoreIMX462 in C3 family – details
We’re expanding the Kurokesu camera family with new models built around the Sony IMX462 image sensor – a standout performer in low-light and near-infrared environments. Designed for starlight-level sensitivity, this sensor offers exceptional performance in dim scenes. Sensor specifications The Sony IMX462 is a 1/2.8″ CMOS sensor optimized for low-light imaging, featuring high sensitivity, low […]
Read MoreIMX477 camera board for motorized zoom lenses
With the introduction of motorized zoom lenses, the next logical step was matching the sensor board. Sure there are countless suitable sensors from various manufacturers like Sony semiconductors, Onsemi, Aptina, and many more. But lack of good support from the SOC side suggested starting from IMX477. It is a reasonably modern 12M image sensor used […]
Read MoreC2 family cameras
C1 family cameras have been a great success with installations around the world (eyes for underwater and flying drones, scientific process observation flying 408km above the Earth on ISS in a low gravity environment, many universities doing computer vision researches, a few industrial environment installations, and many more) It is time to start introducing new […]
Read More