I have a suspicion that my soldering skills are not good enough, and I don’t want to overheat the board by replacing SOC a third time. It means one thing – today is X-ray day! No shorts, soldering could be better, but overall looks ok. Ethernet still does not work. But now, when I know […]
Read MoreEthernet camera module build log #1 – Assembly day
After receiving fresh boards, it’s time to bring the Allwinner S3 CPU-based camera module to life. End even have some output on the console. It’s promising! USB and Ethernet does not work, though. Re-soldered S3 chip, and now USB is working. Ethernet is still dead.
Read MorePlease welcome the Distributor in Ukraine
Ordinary logistics to Ukraine is now restored on regular basis! We are glad to introduce our new distributor, SELTOK PHOTONICS. Today received cheering news: I would like to inform you that the situation has now changed. We carry out deliveries from Vilnius to Ukraine on a regular basis. Quick introduction of our Ukrainian partner, and […]
Read MoreSuspending orders to Russia and Belarus
Russia’s war on Ukraine shook the whole world (more details here). Kurokesu joins the global sanction initiative and stops shipping all products to Russia and Belarus. Companies that have the main office registered in these countries also are blocked. Unfortunately, due to problematic logistics, we can not deliver orders to Ukraine directly. Now we can! […]
Read MoreIMX477 camera board for motorized zoom lenses
With the introduction of motorized zoom lenses, the next logical step was matching the sensor board. Sure there are countless suitable sensors from various manufacturers like Sony semiconductors, Onsemi, Aptina, and many more. But lack of good support from the SOC side suggested starting from IMX477. It is a reasonably modern 12M image sensor used […]
Read MoreScrew-in optical filters
New screw-in filters for C and CS-mount cameras have been introduced on the Kurokesu e-store. Until now, filters were bare glass elements intended to be mounted during camera assembly or in case of camera rework kits installed with double-sided tape. For Kurokesu cameras, this was a somewhat limiting factor for a customer to change a […]
Read MoreNew motorized zoom lenses coming soon
Short announcement – it has been a few years since Kurokesu introduced motorized zoom cameras. So far there was a very limited selection, and it’s finally the time to grow the product line with lenses designed for larger image sensors. While cameras are still in development, only motorized zoom lenses and controllers will be supplied. […]
Read MoreCamera body cap update for CS and M12 cameras
While good at protecting from dust, camera body caps are rarely used with industrial cameras. After the camera is unpacked and the lens is installed usually it stays this way for a very long time. And even if lenses are switched over, the camera very rarely stays with an unmounted lens. Adhesive Polyamide tape is […]
Read MoreC1 PRO vs C2
Preparing to release new cameras and presenting comparison table. C2 camera is still based on Sonix chip-set and IMX290/1 sensor, but superior in many aspects. Most noticeable cosmetic changes are: size, integrated heat-sink and USB-C connector. However many other new features are hidden inside. Below is comparison table: Parameter C1 PRO C2 Chipset SN9C292 SN9C292 […]
Read MoreC2 family cameras
C1 family cameras have been a great success with installations around the world (eyes for underwater and flying drones, scientific process observation flying 408km above the Earth on ISS in a low gravity environment, many universities doing computer vision researches, a few industrial environment installations, and many more) It is time to start introducing new […]
Read More